Quote:
Care to spill any speed secrets?
Did you think it was worth the effort?
Enquiring minds want to know! Did you think it was worth the effort?
| Slant Six Forum https://mail.slantsix.org/forum/ |
|
| Angle Milled Head https://mail.slantsix.org/forum/viewtopic.php?t=68417 |
Page 2 of 2 |
| Author: | Dart270 [ Fri Nov 14, 2025 5:16 am ] |
| Post subject: | Re: Angle Milled Head |
Good to know, Mark. I had a phone call with Stan yesterday and laid out my thoughts and possible advantages... Glad you guys got together in Tulsa. Best, Lou |
|
| Author: | hyper_pak [ Mon Nov 17, 2025 7:14 am ] |
| Post subject: | Re: Angle Milled Head |
Quote: We did.
Care to spill any speed secrets?Did you think it was worth the effort? Is it on the lump of cast iron in my garage? |
|
| Author: | Rick Covalt [ Mon Nov 17, 2025 8:41 am ] |
| Post subject: | Re: Angle Milled Head |
Quote: Care to spill any speed secrets?
Enquiring minds want to know! Did you think it was worth the effort?
|
|
| Author: | Dart270 [ Mon Nov 17, 2025 11:39 am ] |
| Post subject: | Re: Angle Milled Head |
You can tell if a head has been angle milled by measuring with a caliper from deck surface to valve cover machined mounting surface, for the manifold side and then the spark plug side. The measurements will be within a few thou if it has been flat milled, but different if angle milled. Lou |
|
| Page 2 of 2 | All times are UTC-08:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|