Slant Six Forum
https://mail.slantsix.org/forum/

max mill on a slant six head.
https://mail.slantsix.org/forum/viewtopic.php?t=52153		 Page 3 of 3
Author:  USAJon [ Sat Jun 01, 2013 6:45 am ]
Post subject: 
Quote:
I have done a 0.080"/0.180" cut (manifold/plug sides), and up to 0.110"/0.210" on one head. No bolt or washer funny business of any kind. The angles are very slight. One was a 68-74 head and one was a 64 head. These have been on and off motors many times with no problems. Head chamber ranges from 30-40 cc's depending on which mill and which valves/seats you use. Don't make anything more complicated than it needs to be is my motto.

Lou
wondering what was the cost on this work...
Author:  NCDemon1971 [ Sat Jun 01, 2013 7:29 am ]
Post subject: 
Just did the 110 cut on mine. He did it for $100. I think at the 3 thousandths it removes per pass, it took the better part of 8 hours.
Author:  edd jesiolowski [ Tue Jun 04, 2013 10:36 pm ]
Post subject: 
:roll: WHAT WAS HE USING A FILE :wink:
Author:  NCDemon1971 [ Fri Jun 07, 2013 7:20 pm ]
Post subject: 
Quote:
:roll: WHAT WAS HE USING A FILE :wink:
Milling machine. He showed it to me before the work began. He said you could take more than that off per pass--- but it was risky to the bits in the machine. He stated that he would rather do a set of a set of v8 heads in an hour or so for $50 :lol:
Page 3 of 3 All times are UTC-08:00
Powered by phpBB® Forum Software © phpBB Limited
https://www.phpbb.com/