| Slant Six Forum https://mail.slantsix.org/forum/ |
|
| anyone run a temp unit in #1 exhaust Header? https://mail.slantsix.org/forum/viewtopic.php?t=45632 |
Page 1 of 1 |
| Author: | USAJon [ Sun Jul 17, 2011 3:18 am ] |
| Post subject: | anyone run a temp unit in #1 exhaust Header? |
my machinist bro ran a temp unit in #1 exhaust header as He was running alcohol, and he could tune the carb to get the right temp and that would tell him the OK point for the engine.. anyone ever run one for gas use? |
|
| Author: | Ron Parker [ Sat Jul 23, 2011 8:10 am ] |
| Post subject: | |
yea i run on the number onn clyinder on racing fuel Thanks Ron Parker |
|
| Author: | 805moparkid [ Wed Aug 10, 2011 10:05 am ] |
| Post subject: | |
yes you can... but what about cylinder 2 and three? the fuel distribution is all skewed between cylinders due to the intake... this is why im building a tuned length manifold... so if you wanted to do one better you should do cyl 2 so you get a median... P.S. why not run wide bands instead... |
|
| Page 1 of 1 | All times are UTC-08:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|