| Slant Six Forum https://mail.slantsix.org/forum/ |
|
| Slant six 904 torque converter dust cover source? https://mail.slantsix.org/forum/viewtopic.php?t=61312 |
Page 1 of 1 |
| Author: | Matt Cramer [ Thu Jun 29, 2017 3:10 pm ] |
| Post subject: | Slant six 904 torque converter dust cover source? |
My torque converter dust cover got seriously dinged up - I seem to have been a bit too forceful getting that oil pan back on. And it hits the torque converter bolts now. I'm pondering hammering it back into shape vs getting a better replacement. Are there any resto places that have a stash of them? Or any board members have a decent one lying around? Just checking what my options are. |
|
| Author: | DadTruck [ Sat Jul 01, 2017 12:12 pm ] |
| Post subject: | |
Matt, I may have one, will have time tomorrow afternoon to look in the parts attic. |
|
| Author: | DadTruck [ Sun Jul 02, 2017 5:32 pm ] |
| Post subject: | |
Matt is this what you are looking for? https://www.flickr.com/photos/13718356@ ... 2918371674 if so send me a PM with the ship to address regards John |
|
| Author: | Matt Cramer [ Mon Jul 03, 2017 10:16 am ] |
| Post subject: | |
Yes, that's exactly it. PM sent. |
|
| Author: | Pierre [ Mon Jul 03, 2017 2:05 pm ] |
| Post subject: | |
I ran without one for the longest time. Only thing in that area that's sensitive is what... the converter seal? I doubt anything would get to it unless your routinely driving through a foot or two of water. And if it did I'd be more worried about the crank. |
|
| Page 1 of 1 | All times are UTC-08:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|