Slant Six Forum
https://mail.slantsix.org/forum/

Rear shift tab advice
https://mail.slantsix.org/forum/viewtopic.php?t=64293		 Page 1 of 1
Author:  Pgbarrow [ Tue Dec 10, 2019 7:51 am ]
Post subject:  Rear shift tab advice
Hi all,

I have received an order for a linkage and shift tab on my A833 transmission. However, the articulation point for the reverse (what is that called by the way?) only sits about 1/16th of an inch inside the slot in the shift tab. Is this correct? The rectangular portion of the articulation point is also a bit rounded. If I pull that part out could I add some material to the rounded edges and file everything back into shape (via welding)?

Paul

Attachments:
File comment: View of the rounded corners
Tab2.jpg
Tab2.jpg [ 229.8 KiB | Viewed 3190 times ]
File comment: View of the articulation point fully seated in the tab
Tab1.jpg
Tab1.jpg [ 117.11 KiB | Viewed 3190 times ]
Author:  Greg Ondayko [ Tue Dec 10, 2019 10:31 am ]
Post subject:  Re: Rear shift tab advice
when you fit the tab on, and tighten it down it will pull the reverse pin up more flush with the tab.

Greg
Author:  Pgbarrow [ Tue Dec 10, 2019 12:13 pm ]
Post subject:  Re: Rear shift tab advice
Ah ha!

That's the kind of in depth knowledge I need! Thanks Greg, you saved me a lot of effort and headache.

Paul
Page 1 of 1 All times are UTC-08:00
Powered by phpBB® Forum Software © phpBB Limited
https://www.phpbb.com/