Has anyone successfully removed one of these rubber bushings from the throttle linkage, without destroying it? They are hard to come by....
| Attachments: |
|
Linkage2.JPG [ 19.64 KiB | Viewed 5683 times ] |
| Slant Six Forum https://mail.slantsix.org/forum/ |
|
| Carb Linkage bushing https://mail.slantsix.org/forum/viewtopic.php?t=67099 |
Page 1 of 1 |
| Author: | valleyguy [ Sun Feb 19, 2023 4:07 pm ] | ||
| Post subject: | Carb Linkage bushing | ||
Has anyone successfully removed one of these rubber bushings from the throttle linkage, without destroying it? They are hard to come by....
|
|||
| Author: | SlantSixDan [ Tue Feb 21, 2023 3:05 pm ] |
| Post subject: | Re: Carb Linkage bushing |
You grab the body of the bushing with a big pair of pliers, and pull it so the flanged head pops inward through its hole…done. Easy-peay, lemon-squeezy. The bigger question is what you are going to do with this U-shaped piece of metal with the bushing in it. It's not meant to be a separate item like this; it's part of the carb's throttle shaft. Is there some spot-welding in your future? Oh, and the bushing is available as a new part. |
|
| Author: | valleyguy [ Wed Feb 22, 2023 4:27 am ] |
| Post subject: | Re: Carb Linkage bushing |
yes I had intended to try to spot weld this bracket to another carb (which had a different linkage type, but well, that didn't work out..lol, the linkage was just too different to make it workl. |
|
| Page 1 of 1 | All times are UTC-08:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|